Under acceleration, this creates more thrust loading on the left rear tire.Ĥ) Increases the positive arm angle on the left rear and adds bar preload, so at corner exit the bar unloads harder on the left rear.ġ) Moves weight mass to the left, which loosens up chassis at corner entry.Ģ) Increases torsion arm angle at the left front so the car turns in easier.ģ) Lowers the height of the radius rod mounting point on the chassis at the left rear.Ĥ) Takes out positive arm angle at the left rear so car won’t drive as hard at corner exit. You must not put too much force on the crossbar during the process of torsion. This makes the car tighter at corner entry by holding weight at the left front and right rear corners.ģ) Raising the left side of the car up raises the height of the left side radius rod mounting point on the chassis at the left rear. The Actual Adjustment Of the Bar Step 01: Increasing the Chevy Silverado’s Height Lift the car’s frame Place a jack under the crossbar of your car and lift the tires at least 2.5 centimeters above level ground. Affects the car through the first half of cornering.Ģ) Raising the left side of the car up creates a positive arm angle at the left front. So more weight transfers to the right side of the car. Set the rod on 2 blocks then measure the distance from the rod to the front of the rear torsion tubes, it should measure approx. They are light weight come in a pair of two and anodized black. These torsion arm/stop retainers from Schroeder are easy to use, they thread directly into a 7/8 or 1 Schroeder bar. ![]() 3) Use a narrower right rear wheel or more offsetĤ) Raise chassis ride height front and rearģ) Use softer rebound shock valving at left front and left rearĦ) Raise the forward end of the left rear radius rodĤ) Use softer rebound shock valving at right frontħ) Use softer spring rate at right front and right rearĤ) Use softer spring rate at right front and right rearġ) Moves the centre of weight mass to the right. Schroeder Torsion Bar Retainer-Micro/Midget.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |